| Front Panel 
(from left to right):
input one XLR combination with a socket for a 6.3 mm jack plug and XLR male socket
line/mic preamp mode selector switch - line: sources with line level, instruments with active preamplifiers and magnetic sound pick-ups,
- mic: symmetrical microphone input with 24V phantom source
gain input level control
input two socket for a 6.3 mm jack plug, line level
pad switch to adjust input sensitivity - up position: standard line level
- down position: reduction by 10 db/V
gain input level control
clip overload indicator, for both channels colour mid-range contour filter, eq both inputs at the time - Bass: tone control for bass
- Middle: tone control for mid-range
- Treble: tone control for treble
return level control for the internal effect power indicator light master level control for the overall volume
Rear Panel 
(from left to right): outputs phones: headphone output line-out: preamplifier output post-master control DI-out: XLR output pre master control effect loop mono, parallel - send: output, to input of an external device
- return: input, from output of an external device or from another signal source, e.g. CD player
footswitch: connection to a double foot switch to switch internal and external effect on and off power: combined mains switch with a mains socket and a fuse holder (1 A slow blow) accessory: 3/8“ microphone stand adapter carrying bag Further outputs phones: socket to connect headphones to. In use the speaker will be muted.
line out: provides composite signal, with effect, post tone- and master control
DI-out: provides composite signal post tone control, without effect, pre master Features and technical data: input one: XLR Combi - line: unbalanced, 1 MEG
- mic: balanced, 600 Ohm
- Voice filter 300 Hz
input two:
- line: unbalanced, 2.2 MEG
- pad: -10dBV
- eff.return: -10dBV/10k
outputs:
- line: 0dBV
- DI: -20dBV
- send: -10dBV
foot switch
- tip: built in effect
- ring: external effect
- sleeve: ground
EQ: - bass: ± 8 dB/100 Hz
- middle: ±3 dB/550 Hz
- treble: ±11 dB/ 10 kHz
analogue signal processor:
limiter, subsonic filter and enhancer effect: digital reverb power amp: power consumption: 220-240 V / 50-60Hz / 55 VA (110V / 50-60Hz
rating:
40 Watt / 4 ohm rms Mains Fuse: 1 A slow
speaker:
8’ twin-cone speaker-system (96 dB 1w/1m, freq. range 60Hz-18kHz)
cabinet:
0.47’ (12 mm) birch plywood
dimensions: 10.24’ (260 mm) high
10.43’ (265 mm) wide
9.25’ (235 mm) deep
finish:
water based acrylic, black spatter finish
weight:
14.33 (6.5 kg)
*** 0dB/V ~ 1V
*** specifications and appearance subject to change without notice
| 
